Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ 912e mild backfire on deceleration

Posted by: rosenfe Dec 7 2014, 06:19 PM

when i accelerate and take foot off gas ,i get backfire sound -or similar to that.its not loud,but noticeable.any ideas of what to check.these cars have backfire valve,but im not sure how that works.car runs strong,just adjusted valves.someone on 912e forum suggested exhaust system gaskets,but im not sure if they were referring to gasket at headers or muffler.any ideas?

Posted by: rick 918-S Dec 7 2014, 06:29 PM

Is it back firing or popping from an exhaust leak?

Posted by: Mikey914 Dec 7 2014, 06:30 PM

Exhaust leak

Posted by: rosenfe Dec 7 2014, 06:41 PM

well the responses suggest exhaust leak.any suggestions as to how to find it?

Posted by: rosenfe Dec 7 2014, 06:44 PM

more of a popping sound,can i continue to drive it until i find leak or can i burn a valve etc

Posted by: pisces914 Dec 7 2014, 07:01 PM

QUOTE(rosenfe @ Dec 7 2014, 04:41 PM) *

well the responses suggest exhaust leak.any suggestions as to how to find it?


take a look at all of the connection points/gaskets - then look at the muffler itself for any holes, especially if you see seams and welds

hope this helps

brad

Posted by: patssle Dec 7 2014, 07:19 PM

Look for carbon blowout - any darkened areas around gaskets and such.

Posted by: roblav1 Dec 7 2014, 07:49 PM

Yup... exhaust leak.

Posted by: dknechtly Dec 8 2014, 09:29 AM

If you have a two nipple vacuum advance, check that it is good. One of them helps pull back on deceleration.

Posted by: stownsen914 Dec 8 2014, 10:45 AM

Or you already have a burned valve (or not seating properly). The exact symptom I had years ago on my 914 2.0. When I pulled it apart there was a burned valve ...

Check the exhaust leaks first obviously since that's external. You'll hear different methods for doing this, but my favorite is probing around with a length of fuel hose (or other similar sized hose), one end near (but not too near!) your ear, and the other probing around where you think there may be leaks. You'll hear a very audible poofing sound through the hose when you get near a leak.

Scott

Posted by: rosenfe Dec 8 2014, 11:53 AM

noise had gotten louder after adjusting valves.they were definitely tight.im hoping for exhaust leak.heads were recently doen.i dont want to think about burned valve.

Posted by: rosenfe Dec 8 2014, 12:43 PM

would a bad deceleration valve cause this problem?

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)