Printable Version of Topic

Posted by: totle Feb 28 2015, 07:11 PM

Gong to fabricate a GT style rollcage for my GT replica.

Does anyone have the measurments and angles for the roll bar?

Posted by: Maltese Falcon Feb 28 2015, 11:10 PM

Hi Trond,
I think that McMark here on the board is building the gt style bars...check it out with him.
See you over at the Pelican turbo forum !
Marty

Posted by: totle Mar 1 2015, 06:19 AM

Thanks Marty,

Yepp, see you in the 930 forum

Posted by: totle Mar 5 2015, 05:08 PM

Anyone?

Posted by: totle Mar 7 2015, 06:09 PM

Still looking for help

Posted by: Maltese Falcon Mar 8 2015, 01:30 AM

I can give you these measurements, but it's not the style that you are looking for...
Marty

Posted by: totle Mar 15 2015, 03:04 PM

Looking for the measurments around the targa. From door to door around top of targa

Posted by: Maltese Falcon Mar 19 2015, 05:53 PM

Here's a drawing from our bending/forming dept.
Hope it clears up your quest for dimensions.
This bar can be trimmed+cut at the bottoms to suit any height you want.
It fits well and centers nice + even over the tops of the longs.You will need to flip the pic over, or just print it !
Marty

Posted by: SirAndy Mar 19 2015, 08:52 PM

Did you pm McMark, as suggested?