Are these shear bolts holding the switch to the dash?
Attached thumbnail(s)
I am pretty sure they are.
YEP
Did you buy Andy's camera?
Attached image(s)
Yes
Hey Rick,
Here's a picture of the ignition switch I have. Notice the small hole in the bolt. It was drilled and used to back out the screw when the switch was removed from the dash.
They are easily removed with a sharp chisel dug into the edge to rotate it counterclockwise.
They are still available..... or can be re-used by cutting a slot across the head with a hacksaw and tightening with a screwdriver.
They also have a slot machined into the end of the screw so you can come in from the back with a small screwdriver and back the screw out.
I was asked to make the piece that holds the switch to the dash. I pulled my face plate to take a look at the switch and noticed the shear bolts. Here's the plate I made.
P/N 911.347.613.00
Thanks Rick!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)