Can someone tell me the section in the workshop manual for changing the seals on
the output shafts? I can't find the torque for the nut anywhere.
Thanks
Gene
check section 3 : 2/1 to 2/4
I don't have 2/4. I have a cd. Is the trans the same as 911 perhaps that manual will have it. I have a stock factory 6 1971
Thanks
25 to 29 pounds. Did this recently. It is a bolt not a nut.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)