Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ Transmission gurus question

Posted by: Phoenix-MN Mar 23 2015, 03:54 PM

Is this going to be a problem? Maybe the good Dr. can chime in?
Thanks

Posted by: peteyd Mar 23 2015, 06:25 PM

QUOTE(Phoenix-MN @ Mar 23 2015, 01:54 PM)

Is this going to be a problem? Maybe the good Dr. can chime in?
Thanks

I dont have the transmission knowledge like Dr evil, but .03mm is equal to .001 thousandth of an inch. which is about a 1/3 of a human hair. I highly doubt the difference will effect much.

But I am using my experience with machining and tool building, not engine or transmission building.

Pete

Posted by: Phoenix-MN Mar 24 2015, 09:05 AM

After thinking about this more last night, the small amount of wear shouldn't cause any problems with the input shaft seal

Posted by: Bleyseng Mar 24 2015, 09:08 AM

I'd crosshatch it with 1500 grit

Posted by: OU8AVW Mar 24 2015, 11:51 AM

I put mine in a lathe and spun it with a 3m pad to clean the surface.