If I disconnect the fuel line forward of the fuel pump, what kind of flow should I be seeing from the tank. The tank has about 3 gal of fuel.
Thanks,
Jack
steady until empty...
If you mean disconnect the line from the pump on it's outlet port, you probably wouldn't see much flow, very little if any. On the other hand if you disconnect the line from the inlet port you will gravity flow the tank until empty.
I'd guess you'll lose about three gallons.
Thanks guys. I meant fuel filter not fuel pump. If I disconnect the line from the inlet side what should I expect in the way of flow. Sorry.
Carbs or FI?
With D-Jet (can't speak for L-Jet) pump will come on for a few seconds when the ignition is switched on but then shut off until you start the engine. Pressure should be around 30 PSI if I recall correctly.
As for carbs, mine is wired such that the fuel pump comes on with the ignition and remains on, pressure is 3 PSI.
I'm not sure if I'm on the right track for what you are asking, but it appears that you don't have flow out of the pump before the filter, is that correct? If that is the case, do you ever hear the pump come on?
My car is a project that is very close to drivable. A week or so ago I changed the fuel hoses under the tank because I was in there anyway. Today I tried to start the car for the first time in weeks. Started OK before. Today it would chug a bit but not run. I checked fuel flo at the filter inlet. Very weak. I pulled up the tank an the hoses I installed fely very flimsy and prone to kinking. I bought these at bird thinking they were what I needed. That's why I'm asking about flow to the filter.
1974 2.0 FI
I'd pull the tank again and check the internal filter (sock). It's quite possible that it's clogged with varnish.
Carefully remove and clean it or replace it if it's not in good shape.
Be careful with the fiber washers too.
Sounds like you switched the lines at the tank.
Thanks for all the help. Turns out that the fuel lines I ordered were too flexible and cut off the fuel flow, which I what I suspected. I went to the FLAPS and got some overkill hoses and that solved the flow problem. Back on the road after six months of work. Feels great!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)