What material do you guys use for this?
I used neoprene. Got it from my local hardware store. Glued two layers together with trim adhesive, then glued them into place on the firewall. Front bulkhead too.
I think the original stuff was felt? Not sure, but it did a pretty decent job of holding water against the tank and firewall. The carpet that some people have used over the years as a replacement did a really good job of holding water.
--DD
old pc of carpet
Thanks for the quick replies.
Keeping away from the hydrophyllic stuff seems a good idea.
I used furniture pads with adhesive on the back as sold at Home Depot and Lowes. Comes in 4x6 inch sheets.
I used a rubber sheet from the plumbing department
Polyethylene pipe wrap from Lowes, glued in with 3M adhesive. Won't hold water.
I found some adhesive backed felt at Grainger that is a near perfect match to the stock pads. Item # 2FJA9 . Felt Sheet, F3,1/4 In Thick, 12 x 12 In
http://www.grainger.com/product/GRAINGER-APPROVED-Felt-Sheet-2FJA9?nls=1&searchQuery=2FJA9
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)