Shifter knobs best price ever! combine with any other other GBs to save. Who wants one?
Attached thumbnail(s)
Attached image(s)
Yep I will have one!
Hi Mikey. Can you get them with Subaru shift pattern?
I will have three Mark.
I'll take one
I'll take one...
I'll take one
I'll take one.
Man, I'm gonna go broke buying your stuff haha. I don't even think I need one but put me down anyway. Thanks!
I need one as well - thanks!
Will there be a link to the GB price?
Does it come with a crush washer?
Nope
I have one of these on my car. It's very nice, and 914rubber sells the crush washers.
I would like to have one.
I will take one.
I want one too
I'll take one!
Do have it in the 1970 pattern?
:-)
he he he...
I'll be PM'ing all that reply with the link as soon as I open these up.
Also hid some Easter Eggs on the site one big one.
I'll take one as well!
I just ordered parts on Monday, haven't seen its been shipped, but can it be added to the box?
Drop me your name via pm. I would have thought it would have been shipped but ill check.
Mark
I'm in.
I'll take one
One for me. Thanks!
I will take one if still available. Thx
I'll take one. Is it just like in the picture?
I'll take one.
I'm in for one too...
(Actually, just placed my order for this and the speaker pods.... figured while I was there, I'd get them.)
"In".
Please add me to the list.
Group buy open all PMs sent
I want one if they're still available
Still have a few left.
I'd like to have one for my 914 special edition. Thanx
As per PM's. Would it be possible to get with the OEM style inlay but Subaru shift pattern?
http://www.streetfx.com.au/cms/wp-content/uploads/2009/10/p-873-shifter_wrx.jpg
It may be possible to do some up later, but not in this batch. Sorry we can look at these next run.
I will definitely take one!
I'll take one as well if there are any left. Let me know how to pay for it.
thanks
Harlen
I went to the website and ordered two knobs. Then when I went to checkout the shipping cost was $37.00fedex. Wtf? Sorry mark, but I refuse to pay that when they will fit in a small flat rate box (your site says you do not do flat rate?) for 6 bucks.
I re input the size in as it should have allowed it to combine. It appears to work as it should now. Let me know if you have any problems.
Mark
I received the knob this week and installed...thanks! What I had before was some generic knob with an Allen set screw. This design is obviously different.
Very all that is involved in installing this is to put the crush sleeve inside the knob and push down on the shaft as far as it will go? That's what I did but it rotates a bit under force, just wanted to ensure that's normal.
Hmmm, OK. Note that by "it rotates" I mean I can rotate it with my hand, it does not spin freely on the shaft. It has resistance, but it's not as "rotationally-secure" as the Allen-set-screw one I removed.
The issue very well be a reused or weak crush gasket. I know even the new ones aren't great. I cheat and add a drop of epoxy on it. it helps it to "grab" a little better.
I've used this technique to re use them.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)