Hi,
have extra wires and not sure where they go.......A thru F
also.......what covers or what is "G" hole for?
any help would be appreciated...........
thank you
randal
A - heater fan
B - oil pressure switch
C - aux air regulator
D+E - fatter black is coil + terminal 15, thinner one with purple stripe is tach lead, coil terminal 1
F - aux air regulator plugs into C
G - hole for water tray drain tube
Ed beat me to it... (Also can't see the pic well with the background light here.)
--DD
This site is just the best. In less than an hour he had answers from two guys who know their stuff.
yes
you guys are the best.
thank you for helping this rookie as he learns.
now I can mask off the car and start sanding.
thank you
randal
The part of the harness with b,c,d,e run across the back of the engine then under the passenger side intake tubes. It will make sense after that.
thank you mr maker,
the routing of the harness makes all the difference.
thanks again
randal
oops, I have to weld up the extra holes in the doors from the non OEM
mirrors, then I can mask.
another question please.....
where does the white wire attach???
tks
randal
Thermoswitch for the cold start valve... should be right below where it comes out of the harness
thank you, I will look again, must be the trees and forest thing.
randal
found it in a box,, now, ten steps back in order to install it.
thanks again
randal
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)