About to go in and swap out my mounts. Can anyone tell me the torque settings for the transmission mounts? I can't seem to find them, or anything about the transmission mounts, in my Haynes manual.
Thanks
John
Usually you can just use the chart in the 1st chapter I think, it is based on bolt size.
Most of the values if you google that bolt size should within an acceptable range also.
Okay, so now I'm under here I have a couple more questions, before I screw something up
How far do I drop the tranny?
By the look of the bolts that go through the centre of the mounts and into the tranny about 2-3 inches to clear the end of those bolts so I can then slide the mounts down and off, right?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)