Hi Guys,
Well, my (first) 914 is on a truck from CA to NY. 1973 2.0 (with McMark's 2056 rebuild).
New car = new tools!
My other classic is a Ford and most of my shop is SAE. So... what do you guys recommend? I already have a metric socket set, along with standard Hex and Torx sockets from doing brake/rotor work on my Cayman.
First thing I need to do when the car gets here is remove the transaxle and ship it to Dr. Evil (PO disclosed the need for a rebuild and we factored that into the price). He already changed the CV bolts to hex, so I don't need that special dealio.
I already put a set of Metric box wrenches in my Amazon cart. What other reasons can you give me to buy another tool box ?
Here's a pic. Hope it's that nice when it gets here .
Metric feeler gage, long metric sockets, VOM multi meter, timing light, dwell meter or go Pertronix, jack stands, floor dollies, damn good welder; I'll let others pick up the slack here.
AAA card and cell phone for away trips.
Ha!
Thanks. Already have the AAA card. Def the best/cheapest addition to the toolbox.
Ironically, the only time I've ever used it is to flatbed my Cayman after hitting a pothole and shredding a tire. No spare on those .
Jack stands! Jack pads to raise the car a bit to get floor jack under.
Electrical connectors. There are always lose wires.
Metric hex t-wrench set.
Metric tap and die set.
Stubby metric wrench set. There are some tight areas in a 914!
Make sure you have a good set of six point sockets and wrenches. Some bolts are damn tight after 40 years.
Seal puller for the rear main seal. Even if it is not leaking good to replace unless it is a recent build.
If it does not have one get a hard start relay and install while trans is out.
If you don't have one get a cheap USB camera to run off laptop. Very valuable for inspecting areas like the tunnel and under the engine tins to see if any debris are blocking air flow.
M8 triple square for the CV joint bolts. (Also used on a few other fasteners.)
19mm Allen key or socket for the transmission drain and fill plugs.
Ratcheting offset screwdriver.
Deep offset 13mm or 14mm box-end wrench for the jam nuts on the valve adjusting lugs. (Depends on which rocker arms and adjusters you have.)
Haynes manual.
Scrap wood for miscellaneous purposes.
--DD
A set of gear tech metric ratcheting wrenches. And I say this as the son of a 35 yr snap on dealer.
Here is a list of tools you might consider :
http://bowlsby.net/914/Classic/
"Stubby metric wrench set. There are some tight areas in a 914!"
Get the small/medium/large size of metrics from 10mm on up to 19mm. Nothing worse than having the right metric wrench that is just too large to fit into the small spaces.
And welcome! Looks like a great car.
A two post assymetric lift.
I have a QuickJack 5000 lift, so I can get the car about 20 inches off the ground. Low ceilings in the garage, so can't do a full lift.
How often do you use the stubby wrenches?
a way to search 914world that works for me... don't remember who posted this
originally.
https://cse.google.com/cse/home?cx=002408345898193228772:ajvfxschcgc
I have it on my desktop..
much easier to search this site..
randal
8mm x 1.25 helicoil kit
Nice car! and
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)