The owner's manual for my 914-6 calls for 9.5 qts. of oil. After installing my engine for the first time, keeping in mind it was completely apart, clean tank, lines, etc, it didn't show on the dipstick(warm and at idle) until 10 qts were in, and it still shows low.
Any thoughts on this? I am thinking the 9.5 refers to an oil change, there being some residual oil left in the lines,etc.
Thx, Bill
Yup, that sounds about right.
-Steve
You are checking it with the engine warm and idling on level ground? An extra 1/2 quart isn't going to cause a problem.
No enthusiast owned 911 or 914 6 should show oil above the half full mark.
Oil changed , drained both from tank line and motor , took 11 1/2 quarts.
X2
also be aware that there are some incorrect dipsticks in the wild
i b'ot one yrs ago, "certified" oem -6 from a guy who sold us all a lot of -6 stuff - it was nowhere near my real oem stick in length or marks
original -6 German lid sticker says "5 min, 7 max" - see picture
my car with front Behr GT cooler likes 10 qts - if more, it blows it out the vent (and into the track required "catch can")
Thanks for the replies...since my car was all apart when I got it, I am not 100% sure the oil fill neck and dipstick are right. I have a friend with an original six and I am going to stop by and compare the two. If everything looks good, then I will fill it to where it is reading correctly, then see what it takes when I do a simple oil change. That should be the 9.5 qts. I hope!
I think I put in about 11 quarts the first time after my /6 conversion. It was bone dry and no external oil cooler.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)