Does anyone have the dimensions for a 914 seat handy?
Like what? I could go take some measurements, I have a stock seat, and a bare seat.. Could I help in some way?
dimensions of the normal driver's seat:
Overall Height, Width & Depth.
Ok here they are.. now this seat was on the ground, not installed..
Height: 32 3/4 in
Width 18 1/2 in
Depth 25 1/2 without the foam pad, or the handle thing, 26 1/2 with..
This was with a tape measure, and if it was imbetween I went for the bigger 1/4..
Enjoy.
Thanks. I'm thinking about a set of Corvette seats (without their logo).
If you put a sbc then you could keep the logo's!!
84-96 Corvette seats:
Height: 32"
Width: 20"
Depth: 24"
Any reason why they wouldn't fit?
This isn't the seat, but it shows the style...I want tan/beige leather...
Are you going to keep the stock backpad? And how tall are you?
Also, do you have a pic of your interior?
Backpad - yes
My Height - 6'
Pic - only this one
Attached image(s)
I would think that it would be a hard fit, It wont fit in the backpad, as the head area is too big, You probably wont be able to reach your hand down for the e brake. and it might hit your center concle
I have OMP comfort seats and they fit bareluy. http://www.ompracing.it/prod/seats/ha642en.htm
They are 54cm wide, 93 high and 53 deep. Sooo.....
...height is about 36", width about 21" and depth about 21"
BTW, thanks for posting those numbers of Vette seats. I think they look good and I thought to have a pair when I bought the OMPs. I just didnt have any numbers and I thought they would bee too big. It looks like I was wrong.... <_<
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)