So, who the heck carries the red O-ring to seal the taco plate? Need to change out my oil temp sensor and don't want to put an old o-ring back in. Pic of what I need below -
Ansbacher
Let me look, I may have a new one.
That would be cool.
Pelican Parts, man! Looks like they have 1 left in stock.
http://www.pelicanparts.com/catalog/SuperCat/9144/POR_9144_ENGOIL_pg4.htm#item16
you can also change the temp sensor without removing the lower (or upper I guess) plate
but "while youre in there...."
Youll need the two small crush washers (Item 51 N-013-803-2 sealing ring C6 X 10) that go on the two bolts.
Crusty sent me some washers I'll check to see what I've got.
He sold me the last of what he had in stock last time he did them.
Thanks everyone for your help and generosity. I have ordered everything from Pelican (and yes, that was the last o-ring in stock there!).
Ansbacher
I need one too. Getting ready to put together the assembly and mount.
Will this work or both seal and gasket are needed for the taco mounting?
You need both.
Keith
021 101 269A. Elring 762.024 is another part number. Outer diameter is 85mm,Inner diameter is 77mm and 4mm thickness. The material is MVQ Silicone Elastomer.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)