For the record I have tried searching but found nothing on the subject
My new gaskets for the front turn signal lenses seem too small. I can't get them to seal/seat properly. Hopefully there is a simple solution.
I'm believe that rubber shrinks with age but these are new aftermarket seals.
Thanks guys
David
There should be 2 seals for each side:
1. between the body and bucket
2. between the lens and bucket
Perhaps you have the body seal trying to go onto the lens? Just guessing.
Are they front turn signal or side marker len seals. The side marker seals are a balancing act with the lens and the base, and do stretch.
Mark
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)