Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ AAR
Posted by: jack20 Dec 6 2015, 03:49 PM
Hello,
I just removed my AAR and the red lead wasn't connected. The end of the wire was severed (not at the base of the AAR but the terminal end) The spade connector is gone, presumably connected somewhere but I can't find the terminal.
Can anybody point me in the right direction?
Thank You,
Jack
Posted by: pilothyer Dec 6 2015, 04:05 PM
QUOTE(jack20 @ Dec 6 2015, 03:49 PM) 
Hello,
I just removed my AAR and the red lead wasn't connected. The end of the wire was severed (not at the base of the AAR but the terminal end) The spade connector is gone, presumably connected somewhere but I can't find the terminal.
Can anybody point me in the right direction?
Thank You,
Jack
It should connect to the wire that goes to the 12 pin connector on the relay board pin 12
Posted by: Jeff Bowlsby Dec 6 2015, 04:07 PM
It connects to the single white wire in the ignition harness, found in the vicinity of the AAR
Posted by: jack20 Dec 6 2015, 04:27 PM
Fount it!
Thanks so much gents.
Jack
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)