I have a set of early 914 rear flanges that I am going to drill out for a 5 lug conversion, I want to ensure that the stock 914/6 or vented 911 rotor will still be able to be held by the 2 flathead screws...so, does anyone have a picture of which bosses are the correct ones??
do the 914/6 and 911 rear rotors have the same flat head screw thru hole orientation???
I have a pair of rotors - I can post a pic for you.
The screws to hold the rotor on? Yup...
Last time I checked my rears.. lol
I don't think there's a boss there, and you don't really need one.
I use the rotor as a guide and transfer punch the hole location for the rotor hold down screws then drill and tap.
I have a spare set of 5 bolt hubs..... make me an offer. 1970 911
Brand new 914/6 rotors.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)