Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Having trouble with balls....shifter linkage
Posted by: raynekat Dec 19 2015, 07:07 PM
Anyone have a slick trick to getting these popped on?
I've tried everything I can think of but, they are not budging.
The plastic is very hard (no give in it) and it seems like the hole is too small.
I've just about ruined the small lip on the ball that's supposed to lock into the groove on the metal shaft.
Thanks in advance for any thoughts....
Posted by: trick-e Dec 19 2015, 07:33 PM
QUOTE(raynekat @ Dec 19 2015, 09:07 PM) 
Anyone have a slick trick to getting these popped on?
I've tried everything I can think of but, they are not budging.
The plastic is very hard (no give in it) and it seems like the hole is too small.
I've just about ruined the small lip on the ball that's supposed to lock into the groove on the metal shaft.
Thanks in advance for any thoughts....
I think I put the ball in HOT water/microwave to soften it up just a little. Then used a vice and a rubber mallet.
Posted by: r_towle Dec 19 2015, 08:53 PM
Switch to a side shift tranny.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)