I've been thinking of mounting a fire extinguisher just in front the driver seat. I see that Pelican Parts has a sale on the Helgard series extinguishers. It seems like that topic came up be for but can't seem to find it so I'm looking for thoughts on it, to or not to and which one is the way to go if so. Thanks
Don't know about this brand (unknown here in Europe) but be sure that you NEVER use a powder fire extinguisher in a car. The powder is very, very corrosive. Despite that, many of the cheap extinguishers that are sold in automotive shops are these powder extinguishers. Same goes for extinguishers in your workshop off course!
A good alternative is Halotron.
Menno
By far the best is Halon (ie the gas that fills it). Usually denoted by a green coloured bottle (or red with a green flash). Halon is a CFC and production stopped a couple of decades ago. Current extinguishers are from recycled stock of the gas: theoretically unavailable for many years, they are still used in aviation as simply nothing else comes close. They are out there, if you look in the right places.
Bigger is better and Halotron is not Halon, it still leaves a residue.
Both sizes sold should get you out of the cockpit, but they won't put out a substantial fire.
In a substantial fire they may knock it down once, but reignition is very likely. Many fires are fuel pump under the car, pop your load in the wrong place and you may as well be pissing in the wind.
Chemical FE's will fuchs up you car, I had one in the VW bus, kid hit it just a little spritz in the backseat and my amp and speakers were toast. I was lucky that was all I lost.
Halon is getting super expensive and the hard install foam systems are over $5-600+ and can not be exposed to freezing temps.
Halon dissipates real fast, so again reignition is likely.
That said it's better than nothing.
Another one to look into is the Blazecut system sold by Jogr.
[quote name='Mark Henry' date='Dec 24 2015, 04:20 AM' post='2280985']
pop your load in the wrong place and you may as well be pissing in the wind.
Sorry but I had to go there.......
Sounds like changing fuel lines regularly is a better option....
[quote name='Coondog' date='Dec 24 2015, 07:51 AM' post='2280992']
[quote name='Mark Henry' date='Dec 24 2015, 04:20 AM' post='2280985']
pop your load in the wrong place and you may as well be pissing in the wind.
Sorry but I had to go there.......
[/quote]
How about CO2 extinguishers? They leave no residue.
I'm for them...
T
Never knew about the corrosive nature of typical extinguishers so it's definitely time to upgrade. Are these "good enough" for someone who doesn't want to hunt for Halon?
http://www.h3rperformance.com/halguard_products.htm
"HalGuard™ is no ordinary automotive fire extinguisher. It contains Halotron® 1, electrically non-conductive "clean" extinguishing agent that rapidly turns into a gas. Halotron® 1 has passed extensive testing by Underwriters Laboratories, and meets FAA requirements. It can be found on commercial aircraft, and is used by airport fire fighters and on the flight line."
Between now and New Years, Zoro tools usually has a 25% - 30% sale on everything including halotron extinguishers with free shipping. I stocked up and have yet to find better pricing.
^ Good to know, thanks. I've bought from Zoro in the past and had a good experience.
Halotron is 50 percent as effective as halon
Make sure you increase the bottle size if you go that route
I went up form a 2.5lb to a 5 lb in the street car when I freshened things last year
Also know that this works by displacing oxygen. On an open flame like an engine bay with a breeze you can not displace the oxygen long. The perfect setting for use is a computer room that is sealed and small. That's what the application was supposed to be. So don't expect it to surpress the fire once it dissipates into the atmosphere
Finally and most important: you will suffocate from halon much quicker than you think when it displaces the oxygen in your lungs. Get away from it. I had a friend with a 914/6 race car. He had a grid fire. He pulled the key for the bottle and started to take his belts off as the bottle was dumping. He passed out in the seat of a stationary car from the halon before he had finshed taking his belts off. The car was still burning and others had to drag him out of the car while he was unconscious. The car burned to the ground. Don't run a nozzle in the cockpit of a race car with a halon bottle (mine is now capped because of my friends experience). Don't dump the bottle while the car is still rolling. The breeze from motion will reduce the effectveness and you may pass out. Stop the car and trigger the system as you are safely out of the car
See above Photo note L/R the magnesium wheel (its the lump) no normal extinguisher will stop a magnesium fire.
More confusing by the moment, still reading.
I did a fare bit of research on this not long ago
For a race car (drain system in winter or heated storage) or if you live in a area that never freezes a foam system is best, but not cheap.
I'm likely going to use a blazecut plus make damn sure all fuel lines and clamps are in good order and battery is secured.
You know what's really bad for your car, standing on the side of the road watching it burn because you didnt have a fire extinguisher. If all you have is dry powder and have to use it. Take the car home and wash it off.
What size extinguisher would work on this ?
Well when all else fails !!!!!!
Best bet an onboard system and a hand held just in case you have to take one with you to help someone else.
Attached image(s)
The onboard system looks like the best but I'm guessing that would be a pretty penny and I don't think that I'll be doing any serious racing which I'm pretty sure that's meant for. I've seen that sort of setup on boats.
I do like the setup with the extinguisher in front of the seat just what I have in mind. So what did you go with on that one?
Looks like halon to me.
I am just about to buy a new Handheld FE for the race car.
I have a built in Firecharger system with three nozzles - Fuel Cell/pump, drivers crotch, engine bay.
I also carry a handheld on the center console as an extra precaution (and in case someone else's car has an incident)
So I was going to get the H3R Performance HalGuard 1.4 lb bottle.
Anyone have anything good or bad about that choice as a backup?
http://www.summitracing.com/parts/htr-hg100c
Another reason I am replacing is that I broke the plastic nozzle off of my current cheap extinguisher by putting my hand down on it and supporting my weight.
This unit looks more sturdy and comes with a bracket.
I ordered a 5 pound Purple K for gasoline related fires and a 2.5 pound Halotron for interior electrical fires. I will make custom mounts on the spare tire cover.
I agree with a previous post, proper maintenance is the best preventive measure.
Look after your fuel lines including the ones under the tank. If you are not sure when they were last replaced its time to do it now.
If you do have to put out a fire chances are it will not be your own so carry a hand held. Mount it where you will be able to reach it before you exit the car. That way if your own car does catch fire you will already be holding it after jumping out. You won't have to face the dilemma - do I go back for it or is it safer to stand well back.
The only times I've used mine in 30 odd years was on someone else's car and on a tent that got ignited by a BBQ.
Maybe the driver "disappeared" to go buy a fire extinguisher?
http://forums.pelicanparts.com/uploads4/914_On_Fire+11107201396.jpg
Classic...... Never stand in front or rear of a vehicle fire. 1970s and 80s had bumpers with shock absorbers that when heated exploded and shot the bumper forward usually breaking the firefighters legs.
Congrats Tony! I'm sure she'd actually be thrilled that you are so proud of her.
Sara and I are at 12 years. I have the best of all worlds. She loves my cars and even has a '68 mustang of her own that she says will go to her grave with with her. She loves to do car related stuff but still happily gives me my space to do it on my own.
She turned 50 this year....holding up far better than I am.
Today I received a Pelican email about an "Element Fire Extinguisher" group buy:
Link: https://pelicanparts.us5.list-manage.com/track/click?u=3f82235c9292a91ab7d6e6025&id=30663e41e7&e=e3b4440dfe
The way I read this, you have to buy 2 to participate.
Regardless, I'm thinking of going this route as my old HALON unit needs refill/rebuilding.
The Element looks pretty impressive for a hand-held unit, but it's not a "blaze cut." On the other hand, this would be easily moved from one old car to another.
Anyone have experience with one of these?
Thanks in advance!
TLG Auto in N. Hollywood (Marco) now carries and endorses the Element. I've not seen and definitely not tested one myself, yet.
I'll be the voice of dissent.
Not a fan of fire bottles in the passenger compartment. Usually a mounted by flimsy brackets that fail to hold the bottle in a crash.
Now you have a loose 5-10 pound projectile in the passenger compartment.
I've had the opportunity to see both sides of this in play. As previously stated by others a small hand held is of limited use on a fuel fire. In my case, it wasn't enough to put out the fire.
I've also seen vehicles in track day related crashes where the fire bottle came loose. Luckily driver had a helmet on.
Put in Trunk or Frunk. Maybe one in each but I'd keep it out of the passenger compartment.
Here's my fire solution(s). I have a BlazeCut system installed under the lid. I do not use a rain tray since I NEVER drive in the wet. I painted the BlazeCut tube black so that it does not show through the engine cover. You might also notice the engine deck lid steel cable restraint on the left side so that when I pop the lid, the hinges aren't slammed and worked until breakage ensues.
And just in case I have a cabin fire, I have a Kidde extinguisher inside my custom built center console box.....
When I’m done with my 6 build (is that even possible?) I plan on using this....
Attached thumbnail(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)