I was trying to install new plastic ressovor lines and can't get them all the way down on the steel feeder tube . I tried some light oil with no luck . What is the best way? I've done the old stove trick . Using PBM new lines .
Attached thumbnail(s)
I'll let you know how this goes ! Looks like a sence from braking Bad .
Attached thumbnail(s)
I have the same issue putting the ferrals in my replacement plastic fuel line,a quick wave over with a heat gun is the trick,they will never come off except with a cutter.
I found boiling water not quite enough.
[/quote]
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)