Well, this weekend I repaired the A/C holes.
Here's the before behind the rocker panel.
Attached image(s)
Here's the after.
Attached image(s)
Here's the before in the front fender.
Attached image(s)
Here's the after.
Attached image(s)
I also cleaned and repainted my rear shocks and rear control arms.
Here's the before shocks.
Attached image(s)
Here's the after.
Attached image(s)
And here's a shot of the control arm.
Hope everyone else had a productive and/or enjoyable weekend.
Attached image(s)
Rob,
You are inspiring me. Never thought of removing the control arm with axle/hub intact. Seems like the easiest way. Once you unbolt the outer bracket is it as simple as removing the inner large nut and pulling the whole assembly off (after cv at tranny unbolted and caliper/disc removed)?
Actually I removed the axle, control arm, shock, spring, caliper/disc as one unit.
Here's my http://www.tampabay914.com/7491401112004.html with the steps I used.
BTW, this was a suggestion by Brad....
You are good.
Lookin good Rob.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)