Posted by: mbseto Feb 23 2016, 11:22 PM
Hey all... Anyone have a car in a state where they can make this measurement? I would be much obliged if you could post it here. Thank you!
Posted by: 76-914 Feb 24 2016, 08:43 AM
Measure it from inside the cabin.
Posted by: mbseto Feb 24 2016, 10:24 AM
QUOTE(76-914 @ Feb 24 2016, 09:43 AM)
Measure it from inside the cabin.
The bottom of my longs do not exist. At least not in stock form. PO welded in angle iron, and of course there is plenty of rust to cloud the issue. I got new outers from RD and I'm forming the inners on a bender. I can use the outers to some degree to get the width from the outer edges of the flanges, but wanted a sanity check out the width of the C-section. I'll also use the purchased wheelhouse piece to help size everything up.