Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Engine build-up question
Posted by: Nozzle Mar 12 2016, 09:20 AM
Hey folks, it's been a while since this engine has had its engine tins installed and the alignment is looking funny to me. Kind of looks like the engine tin perimeter has got all sorts of curves that I don't remember.
From the front ends look like they're drooping:
And from the side it looks like the tin bows up around the intake ports (both sides are like this):
Thoughts..?
Posted by: rgalla9146 Mar 12 2016, 09:29 AM
QUOTE(Nozzle @ Mar 12 2016, 10:20 AM) 
Hey folks, it's been a while since this engine has had its engine tins installed and the alignment is looking funny to me. Kind of looks like the engine tin perimeter has got all sorts of curves that I don't remember.
From the front ends look like they're drooping:
And from the side it looks like the tin bows up around the intake ports (both sides are like this):
Thoughts..?
As good as it gets.
The curve on the side probably looks better from a lower angle.
The front is excellent.
Also, the rear corner will look better when the rear cross piece is installed
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)