Had to put in points cuz the Pertronics took a dump. Had trouble getting the dwell to 45 but made it. Idles great.
Sounds like it's missing intermittanly while driving but I can't feel it. Might be a slight backfire. Timed it to 27 degrees.
After reading that so many are adjusting valves to .005 on their 2.0's I figured I'd give it a try. MAN! are they noisey! I'll re-adjust & see what happens.
Maybe I goofed somewhere & this might be the cause of it's running crappy.
There's new plugs, wires cap & rotor.
Getting very tired of working on this thing with no results (whine )
Also have an oil leak in the vicinity of oil cooler. Can seals be installed from the top with the tin off? I sure don't want to pull the engine again
Might try the electronic ignition again or just go crazy & set it on fire!
.........b
bruce, if the o.c. seals are gone you will know by the lake of oil on the floor and the top of the filter will be full of oil too. look around the oil presure sending unit and look at the area at the base of the oil fill tower. the mailman should be at your door with an item today.
k
Thanks Kev, I wouldn't call it a lake but it's beginning to look like a small pond! Although I can't see it dripping while it's running It's there the next time I go to use it hours later. I'll be under it (A G A I N ) today ...
Replacing the injection runner seals & gaskets sure made a difference in ridding the car of vacuum leaks.
.......b
some have claimed it's not too bad to replace the seals with the engine in. i couldn't get my fat fingers up in there.
k
I think 005 on the valves is tighter than spec so seems to me they should be quieter, not noisier. Maybe should recheck for loose valve or two.
see if there is someone in your area with a lift you might use for a few hours , and save you neck and back. when the values are done "cold", how cold does that have to be? can you get away with luke warm to the touch, or does the car have to sit overnight?
k
QUOTE |
when the values are done "cold", how cold does that have to be? can you get away with luke warm to the touch, or does the car have to sit overnight? |
QUOTE (rhodyguy @ Mar 26 2005, 11:58 AM) |
see if there is someone in your area with a lift you might use for a few hours , and save you neck and back. when the values are done "cold", how cold does that have to be? can you get away with luke warm to the touch, or does the car have to sit overnight? k |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)