Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ R side emergency brake cable routing (914-4)

Posted by: Rleog Apr 25 2016, 09:45 AM

Cable attaches via screw clip to a boss on the underside of the firewall to the left of the center tunnel. Then how does it go in relation to the cables and wires around the center tunnel exits? How does it pass along the R suspension arm?

Thanks

Posted by: Racer Chris Apr 25 2016, 09:54 AM

QUOTE(Rleog @ Apr 25 2016, 11:45 AM) *

Cable attaches via screw clip to a boss on the underside of the firewall to the left of the center tunnel. Then how does it go in relation to the cables and wires around the center tunnel exits? How does it pass along the R suspension arm?

Thanks

It goes below all the cables at the center of the tunnel. There should be a couple of clamps to secure it to the pinch weld.

Posted by: jkb944t Apr 25 2016, 10:28 AM

thisthreadisworthlesswithoutpics.gif

Posted by: Rleog Apr 25 2016, 10:42 AM

QUOTE(Racer Chris @ Apr 25 2016, 10:54 AM) *

QUOTE(Rleog @ Apr 25 2016, 11:45 AM) *

Cable attaches via screw clip to a boss on the underside of the firewall to the left of the center tunnel. Then how does it go in relation to the cables and wires around the center tunnel exits? How does it pass along the R suspension arm?

Thanks

It goes below all the cables at the center of the tunnel. There should be a couple of clamps to secure it to the pinch weld.



Thanks. Slow, as always, but much more fun putting it back together than tearing it apart. Still a ways away but hoping you'll take it back once I get the engine back in it.

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)