I would like to move my car around without the engine/tranny/axles etc. Is it possible to insert ONLY the stub axle, tighten the nut and NOT damage the bearings? I assume it's safe but I don't want to find out the hard way!
Yup, just torque the stub properly and you could roll it cross country.
i wouldnt think youd hurt anything....
as long as the stub axle is pulled and tightened into the hub....
(yes)! you need to tighten the stub axle.
Wasnt that you and a few others that had this discussion last week? Do not roll the car around without at least the stub axles installed. You rolling it over here? I got a trailer if you need it. Let me know.
QUOTE (skline @ Mar 31 2005, 09:11 PM) |
Wasnt that you and a few others that had this discussion last week? |
berto.... you get the ball joints and tie rods taken car of?
QUOTE (Aaron Cox @ Mar 31 2005, 09:26 PM) |
berto.... you get the ball joints and tie rods taken car of? |
Don't fuchup those bearings!
Won't hurt a thing.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)