Printable Version of Topic

Posted by: ntmatter May 12 2016, 10:50 PM

Getting nearly done with my rustbucket restoration - rust cut out and new metal welded in, runs pretty well, new paint, and the final interior bits on the way from the (astoundingly helpful) 914rubber.com guys. While I'm waiting on my new backpad covering and vinyl seats, I have a small handful of assorted fasteners and these jobbies left on the workbench. I could use some help in identifying them from the cognizeti. I'm fairly sure that #1 is a vent thing for the front trunk, but the others have me stumped. Thanks for any advice!


Attached thumbnail(s)

Posted by: Garland May 12 2016, 11:03 PM

1. Front trunk rear most drain hole.
2. .?
3. Peddle board stop
4. Hand brake cable cover, behind drivers seat.

Posted by: jcd914 May 12 2016, 11:04 PM

3 looks like the clutch pedal stop (attaches to the pedal board)
4 looks like the E-brake cable pivot cover (covers where the 2 cable hook to the e-brake handle)

Jim

Posted by: 914Sixer May 13 2016, 05:51 AM

#2 is the drivers door box lid stop

Posted by: mepstein May 13 2016, 07:04 AM

Good one. I knew I recognized it, I just couldn't place it.

Posted by: ntmatter May 13 2016, 09:38 AM

Awesome, thanks everyone! I'd pulled apart the driver's door to fix the cards and reupholster and totally forgot about this. For the trunk holes I just used extra of the rubber tube things (total of 3), so may not need to replace this bit.

Posted by: Jeff Bowlsby May 13 2016, 10:35 AM

#1 looks like one of two drain plugs at the forward engine bay shelf recesses at left and right. Right side = i.e. 'hell hole'