Can the oil cooler be moved alittle if some of the brakets and such are removed???
The oil stand top bolt( where the oil filter hooks up) is leaking . Can't get a socket to clear and a wrench is highly doubtful... If the cooler moved a bit... without doing other harm this would be good.
The four again...
Yes.
Hmm, read this a couple of times. I would leave the cooler alone. Sounds like you need to pull the filter off. I think you can get a 1/4" drive shallow socket up there. You need to make a new gasket from some Gasket paper that you can get from NAPA. next to thinest they got.
got the gasket, getting some thing on that nut is the case, already removed the filter..????
part of the nut is covered by the cooler. stud is real short as not to interfere with the cooler. Unless the cooler can move about a quarter in. I couldnt do this with the engine out!!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)