Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ 78.4 mm stroke for 2270 cc

Posted by: DaveO90s4 May 25 2016, 08:52 PM

Dear brains trust,

I see that one if the problems with stroking LS engines is the fact that the piston skirt comes out of the liner more than for non stroked at the bottom of the stroke. This in turn leads to more piston wobble on the upstroke, increased piston skirt wear and increased oil consumption.

Is this also an issue with the 78.4 stroke crank in a 2270 cc Type 4 engine?

Is that a reason for staying with the 2.0 standard 71 mm stroke and going for a 2056cc engine instead?

Thanks

Dave

Posted by: Jake Raby May 25 2016, 09:32 PM

QUOTE(DaveO90s4 @ May 25 2016, 06:52 PM) *

Dear brains trust,

I see that one if the problems with stroking LS engines is the fact that the piston skirt comes out of the liner more than for non stroked at the bottom of the stroke. This in turn leads to more piston wobble on the upstroke, increased piston skirt wear and increased oil consumption.

Is this also an issue with the 78.4 stroke crank in a 2270 cc Type 4 engine?

Is that a reason for staying with the 2.0 standard 71 mm stroke and going for a 2056cc engine instead?

Thanks

Dave

It can be an issue, if you use a short (stock length) rod and some Pistons. If you use a 5.400" rod and a piston with a 1.112" pin height, or more, you'll be fine.

Posted by: DaveO90s4 May 26 2016, 05:14 AM

Hi Jake, thanks for your expertise. I'll contact the type 4 store and verify that their products meet that spec. Which for obvious reasons I'm pretty confident they will.

Now to find a complete engine to to the rebuild on (leaving my matching numbers engine un-tampered).

Thanks once again

Dave

Posted by: Jake Raby May 26 2016, 10:10 AM

Yep, they sell what you need.

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)