so, i just got my rebuild kit for my 44 IDF Webers from CB and i only got 4 of the small black O-Rings with it.
but i need 8, 4 for each Carb ...
now what ???
Andy
Andy take a " not so shitty" pic
I have tons of Weber 0-rings, they are for IDAs but there may be one that fits closely enough.
QUOTE (TimT @ Apr 13 2005, 03:12 PM) |
Andy take a " not so shitty" pic I have tons of Weber 0-rings, they are for IDAs but there may be one that fits closely enough. |
hehe
lemme look in my Weber box...
Got em,
but Im here and your there, Ill mail them out if you want, theres got to be someone on the left coast that has em
pm me your addy ifn you want them
Attached image(s)
i've got some here in palo alto, andy. will be in SF tonight if you want to meet me in the outer richmond...
QUOTE (nebreitling @ Apr 13 2005, 03:54 PM) |
i've got some here in palo alto, andy. will be in SF tonight if you want to meet me in the outer richmond... |
QUOTE (TimT @ Apr 13 2005, 03:47 PM) |
but Im here and your there, Ill mail them out if you want, theres got to be someone on the left coast that has em |
QUOTE (SirAndy @ Apr 13 2005, 04:01 PM) |
i can't make it tonight but i'll be in palo alto tomorrow night ... Andy |
QUOTE (nebreitling @ Apr 13 2005, 04:10 PM) |
cool. i teach until 8.30pm, after which i'm free. |
What are these o-rings for?
I didn't use mine...
KT
QUOTE (trekkor @ Apr 13 2005, 04:46 PM) |
What are these o-rings for? I didn't use mine... |
When I tightened my jet, the o-ring just slipped over the top.
What should I do?
KT
i was thinking about that too. the exploded parts diagram shows o-rings in the idle air mixture needle valves. i'm not so sure mine has them in . o-rings are pretty generic in size. even the ones in the idle jet holder should be inspected on a once a year basis imho. when they are cracked it can be hard to see unless you use a sharp eye. the ring on the air mix screw makes sense. it regulates the passageway controlling air bypassing the butterflies. if air is coming in around the screw it could affect tuning maybe? i have a tiny sneeze at thottle tip in. i know exactly what cyl it's coming from. thomlinsons' manual covers this nicely on p.64. note the throttle plate positioning at the upper opening. pretty important. how do you check this?
k
Sumbitch!!!!!
Mark this day on your calendars. Andy took decent pics. Those are nice man!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)