I'm trying to find grommets for another application
The open one is a good feeling t but I'm trying to use it as a plug in my engine shroud where stock 911 mfi injectors go. So ideally looking for a plug without a hole
I can't read the part numbers in this spare parts bin grommet next to it
I think it might be a 4cylinder accelerator grommet
Is that what it is?
Anyone know where I can buy 6 of them?
Attached thumbnail(s)
I've seen a couple of those on fours. One on the engine shelf for oil temp wire and one on the rear vertical tin for the starter harness.
http://www.clarkrubber.com.au/wiring-grommet.html
http://www.clarkrubber.com.au/pull-through-grommet.html
http://www.clarkrubber.com.au/blind-grommet.html
Going to be a VW part number . Look at Bus engine tin rubber.
Blind grommet looks like the ticket.
Letme know if you can't find em.
You should make every grommet on the car mark.
you guys are amazing..
the blind grommet looks like that is it!
Mark,
I can send you a PM, but I didn't see that grommet on your site?
it looks like the clark rubber ones come in 32mm or 38mm
unfortunately I need a 36mm (could probably get by with a 35mm)
Mark, what do you have in mind? anything close to 36mm?
brant
Google metric blind rubber grommets. Lots of hits.
I found a few. Australia. Great British . And Chinese
I'm be got a Chinese sample coming to see
Fingers crossed
Does it have to be metric? 1.41". Do they have one for a 1 1/2" hole?
VW 021 119 569A German Supply has them for $5.83
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)