my driver door handle attachment point (where the bolt is) is starting to crack pretty big....does ANYBODY make good metal replacement parts for these things?
Someone here has a repair for those....URY914 IIRC
Common breakage area....when ANY of mine break I toss them in a pile and then scavenge parts....sometimes the flapper breaks....I have had SOME luck with a spot weld.
i talked to DDD about that awhile back and he suggested that some people layer sheets of epoxy and metal together to make a repair sandwich....but i dunno. I'd rather have a set machined from billet ONCE and be done with it.
That's cool and all--but how much would you pay for it?
(Thought so.)
Check in the "club member parts" section; one of the guys around here is rebuilding/fixing up the old outer door handles.
--DD
Don't everyone want $500 worth of door handles?
it might be a good canidate for PM, or powdered metal forming...
Would aluminum work good? Then polished or chromed? That would be spiffy and lighter.
I can fix them. I use two pieces of aluminum.
PM me.
Attached image(s)
Again...
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)