As per thread ,reason I ask is I can't see a way to tighten the fitting on the hose in situ,my idea was to remove the tank tighten the fitting and reinstall.keen to know,thanks oh wise ones and
Oh by the way getting closer to getting it running....
Yep, it has to be at just the right angle. Slightly angled toward the engine as I recall
you picked up on it..
its necessary to tighten it prior to install
Take a Sharpie and mark the correct orientation of the line relative to the tank before you take the tank out.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)