I've searched the forum and net to try and find where to get the tools to set the deck height and came up empty. I have a dial indicator gauge set up and was hoping to find the plate or bars I've seen in pictures to check and set the height. Does anyone sell these or do you have to make your own?
Jsaum
I used a piece of .50" aluminum. Quick & easy to drill out.
I use to sell them, but it wasn't worth it. I may have a plate left, but I'm sold out of the hold downs and stand offs.
I have one too ...
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)