Anyone have the measurements for the placement of the 914 emblem on a 72? My panel is not original and has no holes. I've tried searching around but no luck. Anyone able to measure some hole positions for me?
Thanks, Scott
DON'T drill holes!!!!! Take off the tabs and use thin double face tape like everyone does now. Just a spot for rust!!
NEVER drill holes unless absolutely necessary!!
No matter if you use tape or holes, you still need the position, right ?
I hope this helps, this is from my 73 1.7
It is in inches and cm's so I hope you can use it.
to explain, start of the measuremnet is from here:
And then see the width from there:
and the height
I think these are the original positions on my car...but since I am not the first owner I cannot be 100% sure
I do not think any of the previous owner moved them to confuse the next owners :-)
That's awesome!! Thank you!
You are welcome. I get a lot of help here, happy to be able to do something back.
If you need other/better measurements...let me know.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)