I'm going to enlarge the fog light switch hole; ignition switch will be installed there . Question is can I remove the left side dash face without pulling the steering assembly. I've read that the late (75 - 76 ) dash faces differ from earlier years. Currently the dash face is covered with leather.
Picture shows the area; not using the 911 switch, but plan to use sixnotfour's modified 914 switch.
Attached image(s)
The 76 piece ,is very flexible ,,I made a pilot hole , then pulled it away and enlarged the hole to what I liked..scary stuff ..
Attached image(s)
this was the first trim , I have since enlared it more like on OG six.
Jim, its way easiest to doit all at once..
Attached image(s)
As you can see from the metal, unless you cut it (which you could do) you would have to do at one time. I think you could do it.
The early, late and the one we make shown
Attached thumbnail(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)