Getting ready to install the front calipers and realized there are 2 bleeders. What's the process on using 2 bleeder valves to bleed the brakes, I usually just use my bleeder cup with a single hose and start pumping but have never had calipers with 2 ports.
Thanks
use the top one for bleeding air; the bottom one is for bleeding out the old fluid.
Ok, that makes sense to me.
Thanks
Refresh my memory on this, after doing the brake job and bleeding is there a switch to reset on the master cylinder for the blinking light on the dash. Its been about 7 years since I've done a brake job on a 914.
Thanks
Yes on the side of the master cylinder where the electrical connection is there is a switch
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)