Printable Version of Topic

Posted by: Mark Henry Jan 21 2017, 12:10 AM

The length, width and the size of the radius? Also how deep should it inset in.

Like this





Thanks Mark

Posted by: Mark Henry Jan 21 2017, 12:14 AM

Posted by: mepstein Jan 21 2017, 05:30 AM

All I have is a fiberglass GT front valance - which I'm happy to measure, trace a pattern, ship to you, ect.

Posted by: Mark Henry Jan 21 2017, 07:22 AM

Thanks Mark, is this just a "that dun dar looks about right" mod?

If so just measure the opening L & W and then I just need the radius of the ends.
For some sneakin reason I bet a paint rattle can will fit right in that radius

Posted by: mepstein Jan 21 2017, 07:41 AM

It's one of the manufactured fiberglass ones.


Attached thumbnail(s)

Posted by: Mark Henry Jan 21 2017, 08:04 AM

I mean the opening on the bumper
But measure the opening on that for me please.

Posted by: Harpo Jan 21 2017, 08:44 AM

http://www.914world.com/bbs2/index.php?showtopic=257807&hl=GT+bumper

I just confirmed that 19.5 x 1.5 inches with 3/4 radius is what I used

Posted by: GeorgeRud Jan 21 2017, 09:09 AM

BTW, taking a hole saw and drilling holes between the factory openings will increase the airflow through your cooler (assuming you have a larger area for the air exit).

Posted by: Mark Henry Jan 21 2017, 01:07 PM

The big difference I see is the radius

so 19.5" X 1.5" with a 3/4" radius?

This is for the bumper group buy, so I want to get it right.