Taping up the loom in the wiper mechanism area I found a brown/black wire folded up and taped into the loom.
Can anyone tell me what this is for?
I have the wiper motor correctly wired up as per the drawing I found and there are no spaces left to connect to.
The fresh air motor connector is fully wired as is the fuel sender. The brake like switch is a single wire and is down in position.
I cannot fit this wire anywhere in this area.
If I'm not mistaken... It's for the intermittent wiper relay
Like this? Believe it goes to pin 5 on the wiper stalk.
Thanks for help.
My car is a 74, why would it be taped off? Is the intermittent phase an optional extra?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)