This is a part that is often missing or melted on original six cylinder cars.
It covers the shift linkage at the rear of the trans.
It's a bit different than the one seen on a 4cyl.
Can it be reproduced ? I think it's 'blow molded' or 'vacuum molded'
Is there a market for it ?
It is a CW item for sure.
Attached image(s)
Blow molded it can be done. I've made the late shif bushings and will be starting up on all of these(I have some), after I get a few other projects completed.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)