I am working on my electrical system so its ready when my engine is done. I am testing the headlights and found that the headlights are popping up when pulling the headlight switch but not going down when I push the switch off. Any ideas?
Did you mess with the adjustment knobs?
I have a couple of known good motors from my car (75). If you want them, I work in Santa Clara near the airport.
Since its both of them...wouldnt it rather be the switch thats faulty?
Mike -
most likely the wiring on the headlite switch to the relay is goofed up or just has come loose
it's a convoluted setup twixt multiple switches
yo can find good diagrams if you search here or google it
here is a good start
http://www.914world.com/bbs2/index.php?showtopic=20605
http://www.914world.com/bbs2/index.php?showtopic=215726&hl=turn+signal
http://www.914world.com/bbs2/index.php?showtopic=272915
http://www.914world.com/bbs2/index.php?showtopic=105013
fwiw i recently rewired mine so they only pop up on full ON, not in park position, and rewired my TS so the euro park & individual gage signals both work correctly - took a LOT of hours -
If it's been more than 6 hrs, I think you're supposed to call your doctor.
Mine have done this before. The pull knob on the switch was screwed in too far, backed it out a little bit till the headlights went back down.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)