I recently ordered a set of larger (32mm) vents from CB performance to swap out for the 28mm vents that come with the Empi 40 HPMX carbs. I went to install them tonight and noticed there is some serious slop as the CB vents have a smaller outer diameter than the OE (empi) vents.
Here is the OE Empi:
http://s120.photobucket.com/user/cameraman123_photos/media/IMG_2705.jpg.html
Here is the CB:
http://s120.photobucket.com/user/cameraman123_photos/media/IMG_2706.jpg.html
Empi on bottom, CB on top:
http://s120.photobucket.com/user/cameraman123_photos/media/IMG_2707.jpg.html
http://s120.photobucket.com/user/cameraman123_photos/media/IMG_2709.jpg.html
Is this normal? I emailed CB but have a feeling they are going to tell me there's not much they can do. Any thoughts?
I'd send em back.
I order my Weber stuff from http://www.piercemanifolds.com.
CB seems to be hit-or-miss much more these days. I haven't ordered anything from them the last time they screwed it up. Like Mark, I prefer Pierce, or my buddy over in Italy.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)