i need to text fit this suby engine/trans cradle so i can determine where to place the trans hanger sections and orient it properly.
Attached thumbnail(s)
Jim, I've got a '75 body up on a cart in my garage you're welcome to use as a guide. I'm missing one piece of engine shelving, as I haven't got around to that body section yet, but I would think it would work for your purposes.
If you're over at Rod's, I'm just down the road (if you remember).
rob, of course, thanks.
all the crazy avatars and screen names mixes the hell out of me and the region of my brain responsible for membering stuff : )
does your car have engine and trans mounts installed?
Attached image(s)
hum, should be still doable.
sample pic from under engine bay.
Attached image(s)
got wooden jig set up for get rear mount points in place.
once i get this tacked up, i will take over to rob's to see how it fits to car.
i did have to hog out the front mount holes about a 1/4 inch outward on both, this is because my cross bar was a bit short and i had to weld a decent gap which must have pulled the whole cradle tight inward.
Attached thumbnail(s)
Looks good, Jim. My tub will be excited to be useful for something other than being a place for me to throw my crap
looks good though i wish it were DEAD NUTS/SPOT ON measurement wise
if i did not spend the past hour with rod drinking RONIN at crooked run brewery, i'd be at your house fitting my cradle
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)