ok, i have a 70 911, and the front suspension is shot, but i want to take the hubs and brakes, and switch them to the teener. what stuff do i need to take off to make it work, in front and back. I know i need the E-brake stuff, but dont know exactly what else. Thanks again!
You are going to atleast take the whole strut from the 911. They are different but will bolt onto the 914 control arms. Then you can use the brakes and everything. The rear isnt going to help you much.
How is the suspension shot? Was it run without bushings? A-arms bent? Or does it just need a full overhaul (bushings, bearings, struts)?
i have a 72T front end on mine. m calipers.
dude
nab the whole 911 setup. bigger t bars stock (19 vs 17mm) and just do new bushings,bearings,balljoints, etc. everything.
Ya ...the early stuff from the 911 will fit...then yer gonna get the itty bitty 911 brakes versus the later SC and Carrera biotch from the board.....
If it's FREE...go for it. Don't pay for it.
YMMV
You can either take just the stuts off (with brakes) the 911 and put it on you 914, if you have a later than 72 teener you will need early ball joints. Or drop the whole front end, steering rack and all - that will be the easiest way to go as one piece. You'll need to steal the wheels of course and change to 5 lug hubs in the rear along with new rear wheel bearings.
Whats the max rim you can fit with that setup...without putting on flares?
With the rear fenders rolled out some I have 15x7 with 205-50-15 tires all around.
QUOTE (cametal @ May 13 2005, 09:14 PM) |
With the rear fenders rolled out some I have 15x7 with 205-50-15 tires all around. |
6" should fit without any mods and if you use a 205x55x16 tire (and 16" wheels) your speedo will be just about dead nuts on.
QUOTE (Leo Imperial @ May 13 2005, 09:09 PM) |
Whats the max rim you can fit with that setup...without putting on flares? |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)