Is there a "standard" for replacing the front clip on a 914? Does it matter if the old front is removed inline with mid point of wheel well or should the cut be make in front of firewall? Thanks in advance for the input.
If you get one of those 914 Factory Repair Manuals on CD, that has all of the factory recco'd body cut lines & bracing in the Body section. There are several vendors who sell the CDs in the $30-40 range, which are basically scanned paper manuals. So if you have or have access to a paper manual close to you, same thing.
I think that Auto Atlanta, Stoddard, Sierra Madre Collection, & maybe some others carry the CD manuals.
Tom
///////
I can burn a CD if you need one. I talked to Richard and he has a set of factory manuals.
I tried to attach a file, but it was too big. Get the FWSM.
Thanks everyone. I have a set of factory manuals and will research there.
Show us a picture
I'm located in Temple/Belton. I'll post some pictures later this week. What shop can pull the front end? Unless the vin tag was covered with bondo when the original front end damage was repaired, I don't think it exist. I'll investigate that further this week.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)