The other day I posted a picture of my 12 pin wiring on the regulator plate asking about the jumper between pins 10 & 11. I got a quick response (thanks McMark).
\
A few minutes later I got a personal message from Mark at 914Rubber stating he noticed how my 12 pin connector was missing and the pins just stuck onto the male posts.
He said that 914Rubber has some of these 12 pin connectors (both halves) and he would sell me one. It arrived in 2 days.
Here are some pictures of a real problem solver and a very hard part to find.
Well Done - Mark!
PS: I hope I'm not jumping the gun here.......
That motor looks sexy.......
I saw the before and had to get him one of the prototypes. Will have the GB on these shortly.
Any yes, very nice looking motor
Attached image(s)
That motor looks familiar......
I's it still running well Mike?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)