Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Side Shifter cup bushing
Posted by: Kansas 914 Aug 5 2017, 09:28 AM
Should the white bushing located in the side shift transmission end press on to the rod or simply reside in the housing.
The pictures I have seen it appears to be pressed on the lever. Mine is pushed back in the housing.
Thanks in advance!
Posted by: Kansas 914 Aug 5 2017, 10:39 AM
I pulled the housing and the cup does snap on to the shifter selector lever coming from the shift console.
Posted by: Mark Henry Aug 5 2017, 10:39 AM
Normal.
It might get stuck in there as it gets older, but that's typical and nothing to worry about.
Posted by: ndfrigi Aug 5 2017, 10:40 AM
ooops edited: Sir Mike, my experienced with it after around 8x replacing/removing that part, the bushing will come in and out of the small lever. But the bushing cannot easily be remove from the knockle (round end from the console lever). Meaning you have to push in or press in the bushing to the knockle first. Hope it helps you!
Posted by: Kansas 914 Aug 5 2017, 10:40 AM
Normal.
It might get stuck in there as it gets older, but that's typical and nothing to worry bout.
Thanks Mark - I installed a new one from 914Rubber. I should be good for another 40 years!
Posted by: Kansas 914 Aug 5 2017, 10:42 AM
Sir Mike, my experienced with it after around 8x replacing/removing that part, the bushing will come in and out of the transmission console lever. But the bushing cannot easily be remove from the knockle (round end of the long lever). Meaning you have to push in or press in the bushing to the knockle first. Hope it helps you!
Thanks Noel - I am buttoning it up now.
Posted by: ndfrigi Aug 5 2017, 10:44 AM
Sir Mike, my experienced with it after around 8x replacing/removing that part, the bushing will come in and out of the transmission console lever. But the bushing cannot easily be remove from the knockle (round end of the long lever). Meaning you have to push in or press in the bushing to the knockle first. Hope it helps you!
Thanks Noel - I am buttoning it up now.
sorry my bad, edited my 1st message.
Posted by: Mikey914 Aug 5 2017, 11:43 AM
I know there's another thread on this but...
Got these on sale for $1.99 This weekend only.
http://shop.914rubber.com/91142413900-Ball-cup-for-shifter-at-transmission-91142413900.htm?categoryId=-1 
Attached thumbnail(s)
Posted by: Kansas 914 Aug 5 2017, 12:30 PM
I know there's another thread on this but...
Got these on sale for $1.99 This weekend only.
Thanks Mark - I have one in my Shopping Cart - I will push the buy button before the weekend is over. Lots of other goodies too - cheers!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)