Wanting to get my suddenly spare 2.0l off the floor and onto my engine stand. Having trouble finding studs/bolts of correct size to thread into the bottom 2 mounting holes (threaded into the cases)?
Anyone know this off the top of their head?
The threads are slightly munged up, so I will chase them with a tap if I can determine the size.
M10mm X 1.50
Thanks so much...
Did you remove these studs? Only asking as these lower 2 studs on mine are about 5_7mm too short. Was thinking about splicing and welding an extension onto them but if they unscrew that would be a bonus.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)