US and Euro lenses $195 a set. Same price
These are multi port injected lenses. What does that mean?
THEY ARE NOT GLUED TOGETHER !!
Yes, they will not crack apart or have ridges like others we have seen.
The price includes the right and left lenses with the lens to housing seals.
The self adhesive housing to body seals will be 1/2 off if you wan them.
The only drawback with this method of injection is that on the edges the hot resin melts the previously injected resin, so the edges are not a prefect line. You can see this on the edge of the clear easiest. The edges do stick out a little further we are reworking these right now to minimize this. Pictures to follow.
Here's the ones Matt just fitted to his car.
Attached thumbnail(s)
Shut up and take my Money! (again for the 20th or so time)
I'm in for one pair of Euro style lenses, no seals needed as I've already changed those on my housings.
Euros please.
Put me down for U. S. set.
Please put me down for a euro set.
one set for me please- euro set I think - I have euros on the front so might as well match.
I'm in for a Euro set with housing to body seals.
Oh man, these look great. I wish I could justify the expense when I have two adequate sets of lenses already and a 6 engine that needs money and time.
Mark, can you make a French set?
I'm down for a Euro set..
1 Euro set pls...
One set - US.
They look great.
I cant see the issue you talk about with the heating / melting ... Is this something that will be fixed and or is it something that can be "cleaned" up by a sharp knife or file ?
I actually think the seal material you use for the tail lights is to hard, mine dont seal because of it.
the factory seals are much softer.
It's actually an imperfection in design. Will require retooling. A section is slightly too large and makes it sit a little farther out. Honestly I think the AA ones do this too.
I'm just telling you. You can make the decision.
If you are a CW and have OCD, I'd say wait another year when it's revisited. I can say they will be more expensive.
You have a good daily driver to a driving restoration you'll benefit from lenses that will not break apart and are actually smooth. It's not lithe casual observer could tell. And with the extra seal we are including it will help Keep water out.
Mark
These are in stock and I can start shipping out. Sorry, it took me a little while to get this all straightened out.
I have PM'd all that signed up.
As far as the melting I discussed. It's minimal and you may not even notice, but I disclose all that so you are not surprised.
Here is some of the worst I've seen and it's not really in the viewing area.
These will not split apart like The other Brand X or should a say "A"
Attached thumbnail(s)
How did I miss this? I will do a set of eruros.
Slightly more hairy in certain locations
Can I get in on a set of Euro ones , Thank you Bill D.
PM sent
Note- these are not just glued together.
I'll take a set of euro please if still available.
Chris
paid for mine thanks!!!
One Euro set ....please let me know how to pay...thanks
Pms sent to all. Getting a little low on the euros for now, 2 sets left in hand after the ones committed thus far.
A set of EUROS for me as well, Mark. Will be ordering the 1.7L throttle body snorkel too ...
Mark, a set for me please.
Thanks
Can't wait to get these! I have always been very impressed with 914 Rubber and their quality. So my expectations are very high for these.
Mark,
Any Euro sets remaining in the group buy?
Don Ceccarelli
I'd like a set of Euros if available
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)