Im doing a V8 conversion. I bought a used Mallory Unilite distrubitor on ebay. I not sure how it wires up . It has three wires red, brown and green. Most likely this is very simple. I just dont want to fry it.
Thanks
David
Try this
http://www.centuryperformance.com/mallory/techfiles/MA1214M_UniliteDist_RevH.pdf
Thanks,
That helps a lot.
David
you might also invest in a mallory electronic coil and a fuse ( with spares ) for the pickup. no stainless or copper core spiral type wires allowed. don't forget the ballast resistor.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)